[Testing] 11.2.0 build 23 available for testing

[forster at ozonline.com.au]

> Either this NAND is close to complete failure, or else the bad block  
> table has become corrupted.
>
> You could try recreating the bad block table as follows:
>
> ok select /nandflash  scrub!  unselect

Thanks
I suspect a bad block table. They all went in the one event as far as  
I can tell. Since then it does not always turn on first time when I  
press power on. Diagnostics run OK except for nand bad blocks.

But I don't think we want to reset the bad block table till we have  
understood the problem. It is apparently one of a number of XO's that  
wont boot on the new image. If bad blocks are a problem for the new  
image, they are increasingly going to be a problem for the ageing  
fleet of XO-1's

Will try the block table after the new image issue is settled, so  
thanks for that info.

Tony