[Trac #113] LinuxBios flashing procedure seems to need additional step.

[Zarro Boogs per Child]

#113: LinuxBios flashing procedure seems to need additional step.
-----------------------+----------------------------------------------------
 Reporter:  warp       |        Owner:  rminnich
     Type:  defect     |       Status:  new     
 Priority:  normal     |    Milestone:          
Component:  linuxbios  |   Resolution:          
 Keywords:             |  
-----------------------+----------------------------------------------------
Comment (by rsmith):

 Replying to [comment:2 dilinger]:

 >(there is no reset button; the only way to do anything hardware-ish would
 be by pulling the power
 >cable out).

 What rev of board do you have?  My ATest board has a small momentary push
 button (SW11) marked EC_reset located in bwtween the GX and the CS5536.

 Frob the button and the board resets.

 >I actually flashed multiple times (insyde -> LB from build 83 -> older LB
 from warp) with only a >software reset after each.  I got the same results
 with the 8042 each time.  It was only after I >pulled the power cable out
 and let it sit for a minute, did I get proper results from the 8042.

 I very much suspect then that the 8051 on the EC was still held in reset
 until you power cycled the board.

 I'm going to verify that right now.

-- 
Ticket URL: <http://dev.laptop.org/ticket/113#comment:4>
One Laptop Per Child <http://laptop.org/>