[Server-devel] Access Point configuration

[Marten Vijn]

On Thu, 2009-07-23 at 18:59 +0530, Joshua N Pritikin wrote:
> On Thu, Jul 23, 2009 at 12:38:27PM +0200, Marten Vijn wrote:
> > You can de-brick with soldering a tll to serial converter on the board
> > on of the linksys. Then you can have a serial line to bios/dd-wrt.
> > In the bios you can enable tftp to reflash the linksys over network.
> > The are clear recovery howto's on wrt's website.
> 
> Yah, I'll figure it out. Thanks.

actually before you start soldering, you could check
if tftp is enabled 3 seconds while booting
This may give you enough time to open a tftp session
to the box and reflash the the linksys without soldering.

If you have many linksys you want a ttl2serial anyway.


kind regard,
Marten

  

-- 
http://martenvijn.nl                 Marten Vijn 
http://martenvijn.nl/trac/wiki/soas  Sugar on a Stick
http://bsd.wifisoft.org/nek/         The Network Event Kit
http://har2009.org                   13th-16th August 
http://opencommunitycamp.org         26th Jul - 2nd August