Testing the Wireless driver changes

[Ronak Chokshi]

After downloading the firmware, the ARM is told by the boot2 to jump to
a specific location of the internal memory. If the firmware is not
downloaded, the boot2 starts the grab the firmware from the Flash and
jumps to the same location of the internal memory once that is done. The
flash tool does not figure out anything here. The boot2 code is smart
enough to figure that out.

 

Best Regards,

Ronak

________________________________

From: Michail Bletsas [mailto:mbletsas at laptop.org] 
Sent: Saturday, January 19, 2008 10:23 AM
To: Dan Williams; Ronak Chokshi
Cc: Ricardo Carrano; devel; David Woodhouse; Giannis Galanis;
networking at laptop.org
Subject: Re: Testing the Wireless driver changes

 



> 
> Does the Boot2 code take care of figuring out the correct address to
> write the thick firmware to, or does the flash tool have to figure out
> the address to write it to?  Normally this address is embedded in the
> firmware flash file header, is there an address the tool should check
> for to verify, or is that address completely irrelevant because the
> boot2 code is smart enough to figure out where to put it?
> 
Dan, 

You have to ask Ronak that. Right now the flash writing logic lives in
the firmware. 

M. 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.laptop.org/pipermail/devel/attachments/20080120/44034a83/attachment.html>