[Trac #189] Mechanical interference - Q1 vs serial connector

[Zarro Boogs per Child]

#189: Mechanical interference - Q1 vs serial connector
-------------------------------+--------------------------------------------
 Reporter:  wmb at firmworks.com  |       Owner:  mfoster
     Type:  defect             |      Status:  new    
 Priority:  normal             |   Milestone:  BTest-2
Component:  hardware           |    Keywords:         
-------------------------------+--------------------------------------------
 On the preB boards, it is very difficult to remove the plug from the
 serial connector J1, because the plastic flange slips behind the body of
 Q1, thus locking the plug into place.

 To remove the plug, you must gently pry the plastic flange over the top of
 Q1.  This is rather tricky, especially if you don't know to do it (it's
 very hard to see).

-- 
Ticket URL: <http://dev.laptop.org/ticket/189>
One Laptop Per Child <http://laptop.org/>