[OLPC-devel] 1M config file

[Marcelo Tosatti]

FYI, I had problems with my e-mail so you might have not received
this message.

Sorry

On Mon, Jun 12, 2006 at 02:46:49PM -0300, Marcelo Tosatti wrote:
> On Sat, Jun 10, 2006 at 09:51:51PM -0600, Ronald G Minnich wrote:
> > 
> > I can't test it ... I can't flash the 1M parts I got on the rumba. I 
> > will have to set up an OLPC as a flasher.
> > 
> > On jordan's kernel, with ub.c, I am still at this point:
> > 
> > sbcore: registered new driver ub
> > PCI: Enabling device 0000:00:0f.4 (0000 -> 0002)
> > ohci_hcd 0000:00:0f.4: OHCI Host Controller
> > ohci_hcd 0000:00:0f.4: new USB bus registered, assigned bus number 1
> > ohci_hcd 0000:00:0f.4: irq 10, io mem 0x10002000
> > usb usb1: configuration #1 chosen from 1 choice
> > hub 1-0:1.0: USB hub found
> > hub 1-0:1.0: 4 ports detected
> > usbcore: registered new driver libusual
> > 
> > I have two keys on there, pretty standard ones, but they don't seem to 
> > be registering.
> > 
> > So I'm almost there ... is there anything I might be missing from this:
> > CONFIG_USB_ARCH_HAS_HCD=y
> > CONFIG_USB_ARCH_HAS_OHCI=y
> > CONFIG_USB_ARCH_HAS_EHCI=y
> > CONFIG_USB=y
> > CONFIG_USB_OHCI_HCD=y
> > CONFIG_USB_OHCI_LITTLE_ENDIAN=y
> > CONFIG_USB_LIBUSUAL=y
> > 
> > Just for a bit, if I get this usb key up, I'm probably still going to 
> > kexec from the raw partition on the drive, just so I can get something 
> > going.
> 
> Do you get any kind of notification by plugging/unplugging the device?