[OLPC-devel] Error on installation

[Anderson Briglia]

On 8/8/06, Christopher Blizzard <blizzard at redhat.com> wrote:
> Anderson Briglia wrote:
> > I just followed the instructions available at
> > (http://wiki.laptop.org/go/Installing_Fedora_Core#Getting_Ready_to_Install)
> > to install the Fedora Core into an OLPC board (PCB A) but the
> > installation stops at "An error has occurred - no valid devices were
> > found ..." error. Anybody can tell me what I'm doing wrong?
> >
>
> At what point did you see that error?  In the installer?  Or once you
> did the install and tried to reboot?
>
> If it was during the installer that usually means that it couldn't find
> USB install media that you wanted to install on.

It was in the installer but I already found the solution. I read again
the wiki page (after send this email to the list) that I mentioned
before and there is an USB hub issue reported there. I just
disconnect/connect the USB hub after the boot process and everything
worked.

Thanks.

Anderson Briglia